Natural Gas Odorization / 2026-07-01
Article Summary
Natural gas odorization introduces an odorant so that a gas release can be noticed by smell. For a gas utility, managing odorization also means reviewing the odorant-related records at relevant stations and distribution points. Where THT is the selected odorant, an Online THT Odorant Analyzer supports a sampling-based monitoring workflow, trend records and exception follow-up. This role differs from a combustible gas detector used to warn of leakage into the surrounding environment. Odorization records can help teams investigate changes and document their response, but a reading alone does not establish compliance. The odorant, sampling arrangement and applicable target-market requirements need project-specific review.
Four different questions in gas safety
Adding odorant, measuring its concentration, assessing whether gas can be noticed by smell, and detecting gas in the surrounding air are different tasks. Define the question before choosing the instrument or system.
- Odorant injection: how is odorant added to the gas supply? Injection equipment is a separate scope from concentration analysis.
- Odorant concentration analysis: how much of the specified odorant is present in the sampled gas? Confirm the actual odorant or blend and the measurement method.
- Odor detectability assessment: at what dilution does the gas become detectable by smell? Use the method applicable to the project market.
- Ambient gas leak detection: is combustible gas present in the surrounding air? An ambient detector does not replace an odorant-concentration analyzer.
Why representative sampling matters
ISO 10715:2022 addresses representative sampling of natural gas and gas substitutes, including applications involving trace-component measurement. Its published scope covers dry, single-phase gas; wet multiphase sampling and gas-sampling safety are outside that scope.
Public abstract and scope only. The full standard and a model-specific sampling design have not been assessed here.
- Identify which pipeline point the sample represents and how it reaches the analyzer.
- Review the sample path and site conditions with the supplier rather than comparing instrument specifications alone.
- Use the standard's scope as a starting reference. It does not demonstrate that a particular analyzer installation meets the standard.
Concentration and odor detectability are different evidence
In its 2018 interpretation concerning US LPG pipeline distribution, PHMSA describes instrumented sampling to determine the gas-in-air concentration at which odor becomes detectable. For that case, testing only at the supplying bulk plant was insufficient; sampling was also needed in the pipeline system.
September 24, 2018 interpretation concerning US LPG pipeline distribution; a jurisdiction-specific example, not a global natural-gas compliance rule.
- A THT concentration record and a gas-in-air odor-detectability assessment answer different questions.
- This US LPG case illustrates a measurement distinction; it does not establish a universal THT concentration limit or demonstrate compliance of a Hanwei instrument.
- Identify the applicable assessment method and acceptance criteria for the project market.
What to record before comparing THT readings
Use the following review checklist to keep measurement context with the result. It is not a prescribed calibration interval, sample pressure or alarm threshold.
- Odorant identity and sampling-point identity.
- Concentration units and the reference conditions used in the report.
- Measurement time, analyzer status and any unavailable or invalid result.
- Relevant calibration or maintenance record, investigation and follow-up reading.
From the engineering question to analyzer selection
For a THT concentration-monitoring project, define the sample points and the decision each result will support. Then compare model-specific measurement, sampling, utility and maintenance requirements using the linked selection guide. The Hanwei product page keeps gas chromatography and electrochemical configurations separate.
- Keep the sampling package and installation responsibilities visible in the quotation.
- Treat odorant injection and automatic dosing control as separate requirements if the project needs them.
- Use the related monitoring solution for architecture and operator workflow, and the product page for verified model facts.